BinTerm - Help
Prior Next
  2.1.3 Adjustment from USB- Dataspy - LIN-Bus:


These option is active when you have choice query from USB- Dataspy and the operating mode measure frequency is active. That work only with Windows 98, Me, 2000 and XP and with a USB- Dataspy with LIN- bus.
USB- operating mode LIN-bus:
In the operating mode LIN- bus can you select the serial connection parameter. The LIN- bus like the same how RS485. The difference is, the LIN- bus is a only one wire bus system. The USB-Dataspy must not toggle between send and receive. Also, in the protocol do BinTerm log the echo from the send bytes.
You can activate the Lin- bus with .

With a colored circle in the USB- operating box can you see the sate from Dataspy- Connector:
red Cannot find the USB- Dataspy, not correctly connected.
grey No USB- Dataspy required
yellow BinTerm set the USB- Dataspy into work..
green The USB- Dataspy working fine.




Connection from LIN- connector:
You must connect the lines GND and +12V for power supply. Without +12V become the LIN transceiver no power and it work not right. The LIN line is the data line.
 .
Self test- feature form USB- Dataspy:
At every from the new communication parameters, the USB- Dataspy make self test. In these time, the red LED goes for a short time on. When the lamp is flash, the USB- Dataspy has detect an error. BinTerm take a error- Code on your display.
Prior
www.MmVisual.de

Mail: mm@MmVisual.de
Next